NanoCore12

Product Info

This is a multi-talented interface module, providing support for USB, RS232, and XBee all in one compact easy-to-use package!

• USB-to-RS232 with power breakout: interface to any microcontroller, via a solderless breadboard, your own wiring scheme, or optional DB9P
• USB-to-XBee interface via 2mm socket strips for XBee, with on-board 3.3V regulator, handshaking lines, and reset button to support easy firmware updates
• XBee breakout function: 2mm socket strips for XBee, with two rows of 10 pins on 0.1" center underneath which break out all pins to breadboard or DIP socket, on-board 3.3V regulator for powering XBee, and jumper-selectable option for powering target via 5V or 3.3V

Features:

• provides USB-to-RS232 interface function for any MCU module
• breaks out +5V from USB to power your target board
• brings out RS232 levels of TXD, RXD, and DTR signals to solder pads and optional user-installed DB9P
• provides regulated 3.3V to power XBee and/or your target board
• standard miniB USB connector
• activity LEDs provided for RX and TX monitoring
• 500mA polyfuse protects host computer's USB port from accidental shorts
• small footprint (approx. 1.0x1.5 inches; 25x37 mm)
• XBee pins brought out to 20-pin wide (0.6") DIP footprint
• includes a DB9P connector and an assortment of 6-pin headers (male, female, and right-angle) for you to install, depending on your requirements

Product Details

Your target board can draw up to 500mA from a USB port on your computer; less, if it is plugged into a hub.

This module can be used with XBeePro if you remove voltage select jumper-- just watch out for the reset button!

CAUTION! When used with XBee module, jumper must be set to 3V3 to avoid damage!

Resources